Doc Site

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== 0003·TDS ~ Temperature Sensor ======

===== Description =====

The module **0003·TDS** is specially designed for measuring temperatures in the range 
-55 ° C ~ 125 ° C, especially suitable for temperature monitoring 
in low temperature ovens and preservation processes.


It is based on a monolithic [[https://datasheets.maximintegrated.com/en/ds/DS18B20.pdf|chip]] that offers a resolution of 0,07ºC with an error in the range of -10° C to 85° C (+-)0.5° C.


===== Parameters =====

^ Parameter                     ^  Minimum ^  Typical ^  Maximum ^     Unit       ^
| Temperature Range             |      -55 |          |      125 |  ºC   |
| Measurement Error (-10~85ºC)  |          |          |  (+-)0,5 |  ºC   |
| Measurement Error (-55~125ºC) |          |          |  (+-)2,0 |  ºC   |


===== Connections =====

{{  0003:ds18b20_bulb.jpg?300}}{{0003:tds.svg }} The measuring probes of this device are of the [[https://datasheets.maximintegrated.com/en/ds/DS18B20.pdf|DS18B20]] type, its power is 3.3V and communicate with the equipment through a single cable, in the image you can see one of the probes that we supplied with the device.

The auxiliary terminals has the power supply terminals, gnd and positive, and terminal communications with the probe.

Particular attention must be paid to the connection, it must be as stable as possible, the connection cable will be less than 3 meters and the measuring element, the chip, must be protected from weather agents.
===== Startup =====

===== Configuration =====

===== Use =====